Buick performance tuning in Scottsdale
Buick's performance history is short and serious: the turbocharged Grand National and GNX, the big-block 455 GS cars before them, and the supercharged 3.8 sedans after. Most of what we see is restoration-meets-power work.
- Grand National
- GNX
- Regal T-Type
- GS 455
- Regal GS
- Supercharged 3.8
Two very different Buicks
The Grand National and GNX are 1980s turbo V6s with factory engine management that most owners have replaced or upgraded. Bigger turbos, intercoolers, injectors and E85 are common, and the result only behaves if fuel and timing are mapped under load. We tune aftermarket management such as Holley EFI on the dyno and log boost, AFR and timing as we go.
The 455 GS and Stage 1 cars are carbureted big-blocks. We still tune Holley and Edelbrock carburetors on the dyno, and we tune Holley Terminator and Dominator EFI for owners converting to fuel injection.
The supercharged 3.8 in the Regal GS, Park Avenue Ultra and Riviera responds to a pulley and a tune, and the 2.0 turbo Regal GS can be tuned where the software supports its control module. We check the VIN before quoting.
Engine swaps into older Buicks, usually an LS, are tuned the same way as any other LS swap: send us the engine, the ECU and the parts list.
Rear-drive, carbureted or turbo, same process
Every session starts with an inspection and a boost-leak check, then baseline pulls. On a classic car that baseline often finds the problem: a lean cylinder bank, a tired ignition curve, a vacuum leak. The rollers are rated to 2,000 whp, and each rear tire sits between two 8.5-inch rollers, so most cars need no straps.
We also fabricate the parts these builds tend to need: intercooler piping, turbo brackets and stainless exhaust. See fabrication.
Buick questions
Can you tune my Grand National on E85?
Yes, if the fuel system is sized for it. We check injectors and pump capacity first, then tune on the dyno.
Do you still tune carburetors?
Yes. We tune Holley and Edelbrock carburetors on the dyno, and Holley Terminator and Dominator EFI for conversions.
Can you work on a numbers-matching car without changing it?
Yes. A baseline, a carburetor or ignition adjustment and a dyno sheet don't require changing original parts.
Year, engine and fuel system
Tell us what's under the hood and what it runs on. See also our post on classic car performance.