Genesis G70 and G80 tuning in Scottsdale
The Genesis G70 3.3T and the first G80 3.3T share their twin-turbo V6 with the Kia Stinger GT; later G80s, GV70s and GV80s use a 3.5 twin-turbo. Same approach for both: a careful calibration, cooler intake air and a transmission tune that keeps up.
- G70 3.3T
- G70 2.0T
- G80 3.3T / 3.5T
- GV70
- GV80
- Genesis Coupe
Twin-turbo V6 Genesis models
The 3.3 twin-turbo in the G70 and earlier G80 Sport, and the later 3.5 twin-turbo in the G80, GV70 and GV80, respond to calibration, intakes, downpipes and ethanol blends where the fuel system supports them. As with the Stinger, intake temperature is the first limit in Arizona heat, and we log it over repeated pulls before we add boost.
Tuning depends on the software supporting your model year's control units; support differs between the 3.3 and the 3.5, so we confirm from the VIN before quoting.
- Custom calibration where supported, written on the dyno
- Intakes, downpipes and intercooling
- Exhaust, catalogue or stainless built in-house
- Brakes, pads and fluid
- Lowering springs or coilovers, and an alignment
- Maintenance and diagnostics
On the rollers
Rear-drive G70s run on the rear rollers with each tire between two 8.5-inch rollers, usually without straps. AWD G70s, G80s and the GV SUVs send torque forward through a transfer case, so they run on our AWD dyno with front and rear load controlled.
The rear-drive Genesis Coupe was sold as a Hyundai, with a 2.0 turbo four or a 3.8 V6. It's on our Hyundai page. Electric Genesis models get brakes, wheels, tires and alignment, but no ECU tuning.
Genesis questions
Is a G70 3.3T tuned like a Stinger GT?
They share the engine family, so the approach is similar. The calibration is written for your car, parts and fuel.
Can you tune the newer 3.5T?
Where the software supports its control units, yes. We check the VIN before quoting.
Is my AWD G80 OK on your dyno?
Yes. It runs on our AWD dyno with front and rear load controlled.