
McLaren tuning and service in Scottsdale
Apart from the hybrid Artura, every modern McLaren runs a twin-turbo V8 behind the driver and sends it to the rear wheels through a dual-clutch gearbox. Turbo engines answer to calibration, and that's most of what owners ask us about.
- 570S / 570GT
- 600LT
- 650S / 12C
- 675LT
- 720S
- 765LT
- Artura
- GT
3.8 and 4.0 twin-turbo V8s
The 12C, 650S, 570S and 600LT use the 3.8 twin-turbo V8; the 720S and 765LT use the 4.0. Both respond to fuel, timing and boost calibration, and both make heat. In Scottsdale, intake temperature over repeated pulls tells you more about a tuned McLaren than the first pull does, so we log it every time.
Tuning is possible where the software supports the car's control units; we confirm from the VIN before quoting, and we'll say so if your model isn't covered. The Artura is a hybrid V6 and a newer platform; ask us.
One owner's review says his McLaren runs smoother and performs better than ever after its visit.
- ECU calibration where supported, verified under load on the dyno
- Exhaust: catalogue or stainless built in-house
- Baseline dyno pulls to check a used car's health
- Brakes, pads and fluid for track days
- Alignment to factory or track settings
- Indoor storage with 24/7 recording and alarm monitoring
Rear-drive, mid-engine, low
McLarens are rear-drive, so they run on the rear rollers with each tire between two 8.5-inch rollers; most cars need no straps. Low-profile lifts and careful loading keep the splitter where it belongs.
Eddy-current load control lets us hold the engine at any rpm and load, so the calibration covers part-throttle and boost onset, not only a wide-open sweep. You leave with the sheet and the datalog.
A McLaren owner on Dyno-Comp
★★★★★
“I recently took my McLaren to DynoComp in Arizona, and I couldn’t be more impressed. Richard, the owner, is both a software and mechanical engineer, which gives you peace of mind knowing your car is in expert hands. The team’s attention to detail and dedication to quality is outstanding. They took the time to explain everything, and my car runs smoother and performs better than ever! If you want top-notch service from true professionals, I highly recommend DynoComp. Thank you, Richard and team!”
McLaren questions
Can you tune my 720S?
Where the software supports its control units, yes. Send us the VIN and the parts list and we'll confirm before you book.
Do you need to strap a McLaren to the dyno?
Usually not. Each rear tire sits between two rollers, and we load the car with its ground clearance in mind.
Do you service McLarens?
Brakes, alignment, exhaust and dyno work, yes. Ask about scheduled maintenance for your model.
Model, year and the goal
Tune, exhaust, a health-check baseline or service.
See also: dyno tuning · performance shop





