(480) 596-0500

Classic Plymouth tuning in Scottsdale

Plymouth stopped building cars in 2001, but its muscle cars are still here: 'Cudas, Road Runners, GTXs and Dusters with 340s, 383s, 440s and the occasional 426. That is carburetor, EFI-conversion and engine-swap work, done on the dyno.

  • 'Cuda / Barracuda
  • Road Runner
  • GTX
  • Duster 340
  • Fury
  • Prowler

Book a classic dyno session(480) 596-0500

Three ways a classic Plymouth arrives

Still carbureted. We tune Holley and Edelbrock carburetors on the dyno: jetting, power valve, accelerator pump and the ignition curve that goes with them. A baseline pull often finds the real problem first, whether that's a lean bank, a tired distributor or a vacuum leak.

Converted to fuel injection. We tune Holley Terminator and Dominator EFI, and dial in idle, cruise and wide-open throttle under load instead of leaving the self-learn to guess.

Swapped. A modern Hemi in a classic body is a common build. Send us the engine, the control unit and the parts list, and we'll tell you how we'd tune it with the same tools we use on the Hellcat platform.

  • Custom stainless exhaust, TIG-welded and mandrel-bent in our fab shop
  • Engine builds, assembled in-house and broken in on the dyno
  • Wiring harnesses and gauges for swaps and EFI conversions
  • Brakes and suspension so the car stops and turns like it now goes

Our post on bringing classics to life covers how we approach older cars.

Gentle on old drivetrains

Load control helps a classic as much as a modern car. Instead of repeated full-throttle sweeps, we can hold the engine at a fixed rpm and load while we adjust, which is kinder to an old rear end and transmission and gives repeatable readings. Each driven tire sits between two 8.5-inch rollers, so most cars need no straps.

You leave with a printed sheet, the datalog and a plain-English walkthrough.

Classic Plymouth questions

Can you just tell me what my 440 makes?

Yes. A baseline session gives you wheel horsepower and torque with AFR logged, and that alone often shows what needs attention.

Should I convert to Holley EFI?

It depends on how you use the car. We tune both carburetors and Holley EFI and will tell you the trade-offs for yours.

Do you work on the Prowler?

Its 3.5 V6 is a later Chrysler engine; ask us about tuning. Service, brakes and suspension are routine.

Engine, induction and ignition

Tell us what's under the hood, carburetor or EFI, and what you want from it.

See also: engine builds · fabrication